Guitar Setup
How to Tune a Guitar in Standard Tuning
Standard guitar tuning runs E–A–D–G–B–E from the thick sixth string to the thin first string. Match both the note name and its octave, using the target table below. Select the intended string in the tuner, pluck it alone, and adjust gradually while checking whether the reading is flat or sharp.
Check the intended string and octave
From string 6 to string 1, aim for E2–A2–D3–G3–B3–E4. The two E strings are two octaves apart. The frequency table uses A4 = 440 Hz; for example, low E2 is about 82.41 Hz and high E4 is about 329.63 Hz.
Choose Standard in the tuner and select the string you intend to tune. Check its note and octave before turning a peg. If the reading is far from the expected octave, stop and verify the target instead of continuing to tighten.
| String | Note | Hz |
|---|---|---|
| 6 | E2 | 82.41 |
| 5 | A2 | 110.00 |
| 4 | D3 | 146.83 |
| 3 | G3 | 196.00 |
| 2 | B3 | 246.94 |
| 1 | E4 | 329.63 |
Give the tuner one clear note
Open the tuner, select the string, and use its microphone button when ready. Pluck that open string by itself and let the initial attack settle. Mute the other strings so that their ringing does not compete with the target. There is no need to strum a chord: a single-pitch tuner is answering a single-note question.
If there is no stable reading, reduce nearby noise and try another clean pluck. A harmonic or another ringing string can produce a plausible-looking pitch in the wrong octave. Check the octave label as well as the meter. Waiting for a reliable signal is more useful than turning a peg in response to every brief display change.
Read flat and sharp, then adjust a little
A cent is one hundredth of an equal-tempered semitone: 100 cents make one semitone. A negative reading is flat, or below the selected target; a positive reading is sharp, or above it. Zero is the target. Wait for a stable reading near zero rather than chasing every flicker of the display.
Once the string, note, and octave are correct, tighten the string slightly if it is flat and loosen it slightly if it is sharp. Pluck again after each small adjustment and check the new reading. Peg layouts vary, so follow the pitch change rather than a universal clockwise or anticlockwise instruction.
Recheck the full set
Work from the low string toward the high string, then check all six again. Adjusting one string can affect the others, especially with a floating bridge. A second pass gives a more useful result than treating the first green indicator as the end of the task.
Stop the tuner when finished. If microphone access is unavailable, use the target pitches in the table with another tuner. Once all six strings match, play a familiar chord and recheck any string that sounds out of place.
Practice: tune and recheck
- Read the six target pitches from low to high, including their octaves.
- Open the tuner, choose Standard, select string 6, and enable the microphone when ready.
- Tune one clean open string at a time, checking both target and octave before moving on.
- Recheck all six strings and stop the microphone after the second pass.
References and editorial responsibility
Fretino maintains this lesson and its diagrams. The sources below support the named concepts.
- Fender: Guitar string names
Standard tuning and string numbering.